Porsche 930 1983
For dashboard lighting, fan heater panel, ignition switch etcDiameter: 8mmLength: 19,5mm..
8.00 €
14 piece male terminal set.Length 19mmDiameter 4mmUsed for injector connections, powerseats, rear wi..
26.00 €
Piggyback terminal spade-spade (6.3mm)..
5.00 €
Select this option if you want us to pre-connect the ordered wiring looms to your original G model f..
82.00 €
Select this option if you want us to pre-connect the ordered wiring looms to a new Classic Retrofit ..
60.00 €
Vintage look single pole push /pull switch.Can be used for several functions , rear wiper etc..
11.00 €
Used for several connections in almost any classic Porsche.12 way strip. (can be cut in single piece..
15.00 €
Used for early turn signal wiring (near the fusebox) but also other years...
5.00 €
Green shielded distributor cable from 6 pole CDI box connector to distributor in engine harnessIt ca..
115.00 €
Repair set for backup light switch connection on gear box.Set exists of:1 x As original boot2 x Bull..
34.00 €
Rubber boot used for 2 pole connector type 944.612.547.00..
8.00 €
Rubber boot for alternator / oil pressure sender etc connection, fits 356, 911, 912, etc KRO39..
9.00 €
Rubber boot for starter motor connection...
8.00 €
Rubber boot alternator & fuelpump connection..
3.00 €
Replica rubber for cable entry in door 911 1974-1988, this rubber is mounted on the door mirror harn..
16.00 €
Rubber grommet for wire to interior light switch (left or right)This grommet is used on the brown wi..
14.00 €
Replica rubber for cable entry in fender 911 1974-1988, this rubber is mounted on the front harness ..
12.00 €
Replica rubber for cable entry headlight bucket 911 1974-1988, this rubber is mounted on the f..
12.00 €
Replica rubber for cable entry of wiring to fuel pump.Hole in plate is approx. 30-22 mm, outside dia..
15.00 €
Rubber for cable entry in fender 911 1974-1988, this rubber is mounted on the front harness protecti..
9.00 €
Showing 81 to 100 of 148 (8 Pages)