Porsche 911 1978 SC
Used for early turn signal wiring (near the fusebox) but also other years...
5.00 €
Standard relay socket for 12v relay(You will also require latching 6.3 x 0,8 terminals for this prod..
4.00 €
Green shielded distributor cable from 6 pole CDI box connector to distributor in engine harnessIt ca..
115.00 €
Repair set for backup light switch connection on gear box.Set exists of:1 x As original boot2 x Bull..
34.00 €
Rubber boot used for 2 pole connector type 944.612.547.00..
8.00 €
Rubber boot for alternator / oil pressure sender etc connection, fits 356, 911, 912, etc KRO39..
9.00 €
Rubber boot for starter motor connection...
8.00 €
Rubber boot used on fuelpumps but also for backup light switch..
23.00 €
Rubber boot alternator & fuelpump connection..
3.00 €
Rubber boot oil pressure / oil level sensor / switch Porsche 911 / 928..
12.00 €
Rubber boot used on several switches and sensors.Backup light switch.MFI valves.Brake switchesCold s..
9.00 €
Replica rubber for cable entry in door 911 1974-1988, this rubber is mounted on the door mirror harn..
16.00 €
Rubber grommet for wire to interior light switch (left or right)This grommet is used on the brown wi..
14.00 €
Replica rubber for cable entry in fender 911 1974-1988, this rubber is mounted on the front harness ..
12.00 €
Replica rubber for cable entry headlight bucket 911 1974-1988, this rubber is mounted on the f..
12.00 €
Replica rubber for cable entry of wiring to fuel pump.Hole in plate is approx. 30-22 mm, outside dia..
15.00 €
Rubber for cable entry in fender 911 1974-1988, this rubber is mounted on the front harness protecti..
9.00 €
Self fusing butyl rubber tape, for example to be used on where the tunnel harness exits the firewall..
9.00 €
Single line (green) for back side rear window heater switch.1 x female terminal1 x piggyback termina..
9.00 €
Single line (red) for back side rear window heater switch.2 x female terminal..
9.00 €
Showing 141 to 160 of 236 (12 Pages)